The Japanese WADECO MWS-24TX/24RX microwave solids flowmeter 
 MWS-24TX/24RX 
 Microwave with high-strength penetrating 
 This microwave switch can be effective for monitoring waste, mineral aggregate, powder, granular, asphalt, etc. 
 Level of media 
 MWS series microwave switch level switch is a transmitter and receiver. 
 Transmitter and receiver using face-to-face installation. 
 Microwave transmitter on the meter launch, total output relay when the microwaves are objects blocking the signal. 
 Poor environmental conditions may cause the sensor surface becomes dirty or scraps of paper and other materials attached to 
 Microwave has a strong penetrating, making the sensor can easily penetrate the dirt to complete measure 
 Volume. Therefore, it can be effectively used for monitoring waste, mineral aggregate, powder, granular, asphalt and other media 
 Level. 
 Sensor from dust and surface scarring, steam and suspended particles 
 Microwave emission angle range is wide, easy to install and adjust from the shock impact, reliable operation 
 Can be used for high temperature, high pressure, and other hazardous environments to detect hazardous materials 
 Simple operation can be done to transform a variety of measuring the distance 
 Power supply voltage selectable 100/200Vac 
 One structure, 24GHz, light weight, easy wiring 



 MWS-DP-2 is a use of microwave penetration and multi-Bullock effects of microwave solids flow meter. 
 The sensor probe target substances emission of a microwave signal, part of the microwave is reflected back into the probe to determine them in motion or stationary state. 
 The high penetrating microwave can bow to the probe surface and the pipe made of insulating material. 
 MWS-DP-2 microwave solids flowmeter is particularly suited to the state of motion of the detection of substances such as powder particles in the vacuum duct. 
 Features: free from dust and non-conductive material on the fixtures in the sensor probe 
 Not subject to the effects of dust, steam and air 
 Through the use of guided wave extension components to complete the detection of high-temperature, high pressure and hazardous substances 
 The sensor head must be flush with the wall, can not help but undermine the flow of substances 
 Installation flexibility 
 110VAC/220VAC voltage selection 
 Installation easy to wire; light weight; the overall design 
 Technical indicators 
 Type the MWS-DP-2 
 Measuring principle of multi-Bullock effect 
 Power supply 110VAC/220VAC ± 10% 50HZ 
 The maximum detection distance of 1.5m (based on measured media may be) 
 Frequency / power 24.2GHZ/5.5mW 
 Control output SPDT 250VAC 3A (COS ￠ = 1) 
 Delay to maintain - opening delay; 0.1-10 seconds (adjustable) 
 Keep the - Guan delay; 0.1-10 seconds (adjustable) 
 The role of time since the power supply to the normal working hours of about 8 seconds 
 Power consumption 5VA 
 Operating temperature -20 ℃ to +70 ℃ 
 Maximum working pressure 5kg/cm2 
 Shell cast aluminum, the metal silver, waterproof seal